Hikvision DS-3E1526P-EI24 Port Gigabit Smart POE Switch
Each of the 24 Gigabit PoE ports on the Hikvision DS-3E1526P-EI can reach up to 300 m, so cameras can be placed farther from the network rack. In daily use, one switch supplies both power and data to many cameras at once, without separate adapters or wall sockets for each device. When pairing cameras, check that they support IEEE 802.3af or 802.3at, the standards this switch follows.

Description
Hikvision equipment store: authentic goods with warranty and documents. Dealers and project buyers can request wholesale prices.
Specifications
- Shell
- Metal material
- Net Weight
- 3.1 kg (6.83 lb)
- Gross Weight
- 3.3 kg (7.27 lb)
- Dimensions (W × H × D)
- 440.0 mm × 220.8 mm × 44.0 mm (17.32'' × 8.69'' × 1.73'')
- Operating Temperature
- 0 °C to 45 °C (32 °F to 113 °F)
- Storage Temperature
- -40 °C to 85 °C (-40 °F to 185 °F)
- Operating Humidity
- 5% to 95% (no condensation)
- Relative Humidity
- 5% to 95% (no condensation)
- Power Supply
- 100~240 V AC, 50/60 Hz, Max. 6.3 A
- Installation Mode
- Rack (equipped with mounting ears)
- Max. Power Consumption
- 400 W
- Power Consumption In Idle
- 30 W
- Surge Protection
- 6 kV
- Ports
- 24 × Gigabit PoE port,1 × Gigabit RJ45 port,1 × Gigabit fiber optical port
- MAC Address Table
- 8 K
- Switching Capacity
- 56 Gbps
- Packet Forwarding Rate
- 41.66 Mpps
- Internal Cache
- 4.1 Mbits
- Long Range
- Ports 1 to 24: up to 300 m. Long range performance may vary depend on camera model or cable condition.
- PoE Watchdog
- Ports 1 to 24: auto detect and restart the cameras that do not respond.
- Link Aggregation
- Link aggregation is used to aggregate multiple physical ports to form a logical port for load balancing, bandwidth expansion, and port protection. Support static link aggregation. Support 8 aggregation group(s).
- QoS
- QoS is used to allocate bandwidth to different services so as to provide end-to-end service quality assurance. Support port-based priority configuration. Support SP and WRR priority scheduling modes.
- Loop Prevention
- Loop prevention is used to prevent the switching network from forming loops, which will seriously affect network communication. Disabled by default. Support 802.1D STP. Support 802.1w RSTP.
- VLAN
- VLAN is used for network scale planning and network health improvement. Support 802.1Q. Configurable VLAN ID from 1-4094. Support Trunk, Access port mode. Support Max. 32 VLAN.
- Port Isolation
- Ports 1 to 26: port isolation mode to improve network security Ports in an isolation group cannot communicate with each other, but they can communicate with ports outside the isolation group.
- System Maintenance
- Support device management via web. Support DHCP Client. Enabled by default for dynamic assignment of management IP addresses. Support Super IP, which is a configurable IP address (default: 10.180.190.200) for direct access. Support management via Hik-Central Pro. Support remote management via Hik-Partner Pro. Support cable detection. Abnormal open circuits and short circuits as well as network cable length can be detected. Support 802.1ab LLDP for peer device discovery. Support port mirroring for fault locating.
- DHCP Snooping
- DHCP Snooping can prevent unauthorized connections to DHCP servers from disrupting the network and affecting normal network communication, and only allow DHCP packets from trusted ports to pass through. Disabled by default.
- HPP
- Support one-click activation and remote management via Hik-Partner Pro. Functions supported: 1. Display the port rate. 2. Display the port bandwidth utilization rate. 3. Display the PoE power usage. 4. Display topology information. 5. Display the alarm status. 6. Restart ports and devices. 7. Enable port long-rage mode. 8. Remotely upgrade the device.
- PoE Standard
- IEEE 802.3af,IEEE 802.3at
- PoE Power Pin
- 8-pin power: 1/2(-), 3/6(+), 4/5(+), 7/8(-)
- PoE Port
- PoE: Ports 1 to 24
- Max. Port Power
- 30 W
- PoE Power Budget
- 370 W
- EMC
- CE-EMC (EN 55032: 2015, EN IEC 61000-3-2: 2019, EN 61000-3-3: 2013+A1: 2019, EN 50130-4: 2011 +A1: 2014, EN 55035: 2017);
- Safety
- UL (UL 60950-1); CB (IEC 60950-1:2005, AMD1:2009, AMD2:2013, IEC 62368-1: 2014 (Second Edition); CE-LVD (EN 60950-1: 2006 + A11: 2009 +A1: 2010+A12: 2011+A2: 2013, EN 62368-1: 2014+A11: 2017)
- Chemistry
- CE-RoHS (2011/65/EU); WEEE (2012/19/EU); Reach (Regulation (EC) No.1907/2006)
The figures are taken from Hikvision's own and other vendors' documentation, and might change once models are revised.
Delivery and payment
- Toshkent: omborda bor tovarlar o'sha kuni, odatda bir soat ichida
- Regions: courier delivery in 1–3 days
- Ways to pay — cash, Uzcard, Humo, Click, Payme, or in parts
Frequently asked questions
A single unit costs 2,825,201 UZS. Buying several, for an installation project or for resale? Send the quantity to @KhayitovDev or call +998 93 241 09 07 and we'll work out a separate quote.
The serial number is printed on the label on the housing and on the box, and it also shows in the device's web interface or the Hik-Connect app. You'll be asked for it in any warranty request.
The model is available: we dispatch the same day within Tashkent, and couriers usually reach other regions in 1–3 days.
Yes — businesses pay by bank transfer against an invoice; we agree details and paperwork on +998 93 241 09 07. Private buyers can pay in cash or with Uzcard, Humo, Click or Payme.
Similar products
All Switches →






