Hikvision DS-3E1520P-EI/M16 Port Gigabit Smart POE Switch
The PoE budget of this switch is 125 W, with up to 30 W available on each port, so several IP cameras and access points can be connected without separate power outlets. In daily use, a single cable carries both data and power, which keeps installation simple and tidy. Tip: before connecting the DS-3E1520P-EI/M, add up the power draw of all PoE devices, since the 125 W limit is shared across all ports.

Description
Hikvision equipment store: authentic goods with warranty and documents. Dealers and project buyers can request wholesale prices.
Specifications
- Shell
- Metal material
- Net Weight
- 3.1 kg (6.8 lb)
- Gross Weight
- 2.4 kg (5.3 lb)
- Dimensions (W × H × D)
- 440.0 mm × 44.0 mm × 220.8 mm (17.32'' × 1.73'' × 8.69'')
- Operating Temperature
- 0 °C to 45 °C (32 °F to 113 °F)
- Storage Temperature
- -40 °C to 85 °C (-40 °F to 185 °F)
- Operating Humidity
- 5% to 95% (no condensation)
- Relative Humidity
- 5% to 95% (no condensation)
- Power Supply
- 100-240 VAC, 50/60 Hz, Max. 2.5 A
- Max. Power Consumption
- 150 W
- Power Consumption In Idle
- 20 W
- Surge Protection
- 6 kV
- Installation Mode
- Desk-Mounted,Rack (equipped with mounting ears)
- Ports
- 16 × Gigabit PoE port,2 × Gigabit RJ45 port,2 × Gigabit fiber optical port
- MAC Address Table
- 16 K
- Switching Capacity
- 68 Gbps
- Packet Forwarding Rate
- 50.59 Mpps
- Internal Cache
- 8.4 Mbits
- Long Range
- Ports 1 to 16: up to 300 m. Long range performance may vary depend on camera model or cable condition.
- Port Isolation
- Ports 1 to 20: port isolation mode to improve network security Ports in an isolation group cannot communicate with each other, but they can communicate with ports outside the isolation group.
- PoE Watchdog
- Ports 1 to 16: Auto detect and restart the cameras that do not respond.
- Link Aggregation
- Link aggregation is used to aggregate multiple physical ports to form a logical port for load balancing, bandwidth expansion, and port protection. Support static link aggregation. Support 8 aggregation group(s).
- QoS
- QoS is used to allocate bandwidth to different services so as to provide end-to-end service quality assurance. Support port-based priority configuration. Support SP and WRR priority scheduling modes. Support DSCP-based QoS policy.
- Loop Prevention
- Loop prevention is used to prevent the switching network from forming loops, which will seriously affect network communication. Disabled by default. Support 802.1D STP. Support 802.1w RSTP.
- VLAN
- VLAN is used for network scale planning and network health improvement. Support 802.1Q. Configurable VLAN ID from 1-4094. Support Trunk, Access port mode. Support Max. 1024 VLAN.
- HPP
- Support one-click activation and remote management via Hik-Partner Pro. Functions supported: 1. Display the port rate. 2. Display the port bandwidth utilization rate. 3. Display the PoE power usage. 4. Display topology information. 5. Display the alarm status. 6. Restart ports and devices. 7. Enable port long-rage mode. 8. Remotely upgrade the device.
- System Maintenance
- Support device management via web. Support DHCP Client. Enabled by default for dynamic assignment of management IP addresses. Support Super IP, which is a fixed IP address (10.180.190.200) for direct access. Support management via Hik-Central Pro. Support remote management via Hik-Partner Pro. Support cable detection. Abnormal open circuits and short circuits as well as network cable length can be detected. Support 802.1ab LLDP for peer device discovery. Support port mirroring for fault locating.
- DHCP Snooping
- DHCP Snooping can prevent unauthorized connections to DHCP servers from disrupting the network and affecting normal network communication, and only allow DHCP packets from trusted ports to pass through. Disabled by default.
- DDM (Digital Diagnostic Monitoring)
- Support real-time monitoring of key parameters in optical modules, such as operating temperature, operating voltage, operating current, and Rx and Tx optical power.
- PoE Standard
- IEEE 802.3af,IEEE 802.3at
- PoE Power Pin
- End-span: 1/2(-), 3/6(+)
- PoE Port
- PoE: Ports 1 to 16
- Max. Port Power
- 30 W
- PoE Power Budget
- 125 W
- Perpetual PoE
- Supported PoE remains active during system reboot, except in cases of power outage or PSE firmware upgrade.
- EMC
- CE-EMC (EN 55032: 2015+A11: 2020, EN IEC 61000-3-2: 2019, EN 61000-3-3: 2013+A1: 2019, EN 50130-4: 2011+A1: 2014, EN 55035: 2017+A11: 2020)
- Safety
- UL (UL 60950-1); CB (IEC 60950-1:2005, AMD1:2009, AMD2:2013, IEC 62368-1: 2014 (Second Edition); CE-LVD (EN 60950-1: 2006 + A11: 2009 +A1: 2010+A12: 2011+A2: 2013, EN 62368-1: 2014+A11: 2017)
- Chemistry
- CE-RoHS (2011/65/EU),WEEE (2012/19/EU),Reach (Regulation (EC) No.1907/2006)
The figures are taken from Hikvision's own and other vendors' documentation, and might change once models are revised.
Delivery and payment
- Toshkent: omborda bor tovarlar o'sha kuni, odatda bir soat ichida
- Regions: courier delivery in 1–3 days
- Ways to pay — cash, Uzcard, Humo, Click, Payme, or in parts
Frequently asked questions
A single unit costs 1,658,034 UZS. Buying several, for an installation project or for resale? Send the quantity to @KhayitovDev or call +998 77 567 77 77 and we'll work out a separate quote.
The serial number is printed on the label on the housing and on the box, and it also shows in the device's web interface or the Hik-Connect app. You'll be asked for it in any warranty request.
The model is available: we dispatch the same day within Tashkent, and couriers usually reach other regions in 1–3 days.
Yes — businesses pay by bank transfer against an invoice; we agree details and paperwork on +998 77 567 77 77. Private buyers can pay in cash or with Uzcard, Humo, Click or Payme.
Similar products
All New arrivals →





