Hikvision DS-3E1318P-EI/M(O-STD)16 Port Fast Ethernet Smart POE Switch
Also known as: DS-3E1318P-EI/M
The key figure for this model is a shared PoE budget of 130 W, distributed across ports 1–16, so several cameras and IP phones can be powered at once from a single switch. In daily use, this removes the need for separate outlets and adapters for each device, and the cabling stays tidier. Before choosing, add up the consumption of every device you plan to connect so the budget is not exceeded. The DS-3E1318P-EI/M(O-STD) mounts in a standard 19-inch rack.

Description
Hikvision equipment store: authentic goods with warranty and documents. Dealers and project buyers can request wholesale prices.
Specifications
- Shell
- Metal material
- Net Weight
- 1.8 kg (4.0 lb)
- Gross Weight
- 3.0 kg (6.6 lb)
- Dimensions (W × H × D)
- 335.00 mm × 44.00 mm × 226.00 mm (13.19'' × 1.73'' × 8.90'')
- Operating Temperature
- 0 °C to 45 °C (0 °F to 113 °F)
- Storage Temperature
- -40 °C to 85 °C (-40 °F to 185 °F)
- Operating Humidity
- 5% to 95% (no condensation)
- Relative Humidity
- 5% to 95% (no condensation)
- Power Supply
- 100-240 VAC, 50/60 Hz, Max. 3 A
- Installation Mode
- Rack (equipped with mounting ears)
- Max. Power Consumption
- 150 W
- Power Consumption In Idle
- 20 W
- Surge Protection
- 6 kV
- Ports
- 16 × 10/100 Mbps PoE port,1 × Gigabit RJ45 port,1 × Gigabit combo
- MAC Address Table
- 16 K
- Switching Capacity
- Whole-Device Performance: 9.2 Gbps Port Performance: 7.2 Gbps
- Packet Forwarding Rate
- Whole-Device Performance: 6.84 Mpps Port Performance: 5.36 Mpps
- Internal Cache
- 4 Mbits
- Long Range
- Ports 1 to 16: up to 300 m. Long range performance may vary depend on camera model or cable condition.
- VIP Port
- Ports 1 to 8: data on VIP ports is preferentially forwarded when bandwidth resources are insufficient.
- Port Isolation
- Ports 1 to 18: port isolation mode to improve network security Ports in an isolation group cannot communicate with each other, but they can communicate with ports outside the isolation group.
- PoE Watchdog
- Ports 1 to 16: auto detect and restart the cameras that do not respond.
- Link Aggregation
- Link aggregation is used to aggregate multiple physical ports to form a logical port for load balancing, bandwidth expansion, and port protection. Support static link aggregation. Support 1 aggregation group(s).
- QoS
- QoS is used to allocate bandwidth to different services so as to provide end-to-end service quality assurance. Support port-based priority configuration. Support SP and WRR priority scheduling modes. Support DSCP-based QoS policy.
- Loop Prevention
- Loop prevention is used to prevent the switching network from forming loops, which will seriously affect network communication. Disabled by default. Support 802.1D STP. Support 802.1w RSTP.
- VLAN
- VLAN is used for network scale planning and network health improvement. Support 802.1Q. Configurable VLAN ID from 1-4094. Support Trunk, Access port mode. Support Max. 4094 VLAN.
- HPP
- Support one-click activation and remote management via Hik-Partner Pro. Functions supported: 1. Display the port rate. 2. Display the port bandwidth utilization rate. 3. Display the PoE power usage. 4. Display topology information. 5. Display the alarm status. 6. Restart ports and devices. 7. Enable port long-rage mode. 8. Remotely upgrade the device.
- System Maintenance
- Support device management via web. Support DHCP Client. Enabled by default for dynamic assignment of management IP addresses. Support Super IP, which is a fixed IP address (10.180.190.200) for direct access. Support management via Hik-Central Pro. Support remote management via Hik-Partner Pro. Support cable detection. Abnormal open circuits and short circuits as well as network cable length can be detected. Support 802.1ab LLDP for peer device discovery. Support port mirroring for fault locating.
- DHCP Snooping
- DHCP Snooping can prevent unauthorized connections to DHCP servers from disrupting the network and affecting normal network communication, and only allow DHCP packets from trusted ports to pass through. Disabled by default.
- PoE Standard
- IEEE 802.3af,IEEE 802.3at
- PoE Power Pin
- 8-pin power: 1/2(-), 3/6(+), 4/5(+), 7/8(-)
- PoE Port
- PoE: Ports 1 to 16
- Max. Port Power
- 30 W
- PoE Power Budget
- 130 W
- EMC
- CE-EMC (EN 55032: 2015+A11: 2020, EN IEC 61000-3-2: 2019, EN 61000-3-3: 2013+A1: 2019, EN 50130-4: 2011+A1: 2014, EN 55035: 2017+A11: 2020),IC (ICES-003: Issue 7:2020),RCM (AS/NZS CISPR 32: 2015)
- Safety
- CB (AMD1:2009, AMD2:2013, IEC 62368-1: 2014 (Second Edition)), CE-LVD (EN 62368-1: 2014+A11: 2017)
- Chemistry
- CE-RoHS (2011/65/EU),WEEE (2012/19/EU),Reach (Regulation (EC) No.1907/2006)
The figures are taken from Hikvision's own and other vendors' documentation, and might change once models are revised.
Delivery and payment
- Toshkent: omborda bor tovarlar o'sha kuni, odatda bir soat ichida
- Regions: courier delivery in 1–3 days
- Ways to pay — cash, Uzcard, Humo, Click, Payme, or in parts
Frequently asked questions
A single unit costs 1,326,408 UZS. Buying several, for an installation project or for resale? Send the quantity to @KhayitovDev or call +998 77 567 77 77 and we'll work out a separate quote.
The serial number is printed on the label on the housing and on the box, and it also shows in the device's web interface or the Hik-Connect app. You'll be asked for it in any warranty request.
The model is available: we dispatch the same day within Tashkent, and couriers usually reach other regions in 1–3 days.
Yes — businesses pay by bank transfer against an invoice; we agree details and paperwork on +998 77 567 77 77. Private buyers can pay in cash or with Uzcard, Humo, Click or Payme.
Similar products
All Switches →






